^{1 Suppression in less competitive crops such as field peas and Clearfield lentils.
2 Odyssey Ultra NXT herbicide tank-mix will not control weed biotypes that are multiple-resistant to both Group 1 and Group 2 herbicides.
3 Odyssey Ultra NXT will provide control of spring germinating Japanese brome grass and suppression of quackgrass and fall emerged Japanese brome grass.}

Rainfastness – 3 hours.

Apply in warm weather to weeds that are actively growing.
Avoid applying immediately after or preceding a frost or when temperature is under 5^°C.

Pre-harvest interval

60 days after application for Clearfield lentils and field peas.^**
80 days after application for faba beans.
85 days after application for soybeans.^*

^{*Do not graze treated canola or soybeans or cut for hay; sufficient data is not available to support these uses.
**Field peas may be fed to livestock 30 days after application.}

NOTE: Odyssey Ultra NXT is registered for use only in the Prairie Provinces.

Odyssey Ultra NXT is a tank mix that contains components: Odyssey Ultra (a) and Odyssey Ultra (b).

One case will treat 40 acres

Water volume

^{*For control of fall emerged Japanese brome grass, add Poast® Ultra herbicide (at 90 ml/ha) to the tank mix. See label for details.
**Merge adjuvant is required and is included with Odyssey Ultra NXT in the case, and will treat 40 acres at the 10 gal/ac water volume rate.}

Mixing order

1. Start with a clean sprayer. Fill the spray tank with 3/4 of the required amount of clean water, start agitation and continue agitation throughout the entire mixing and spraying procedure.
2. Add the required amount of Odyssey Ultra NXT (a) and continue to agitate until fully dissolved.
3. Add the required amount of Odyssey Ultra NXT (b) while agitating the spray solution. If required, add the necessary amount of Poast Ultra Liquid Emulsifiable herbicide.
4. After the herbicide is dissolved, continue agitation and add the required amount of Merge adjuvant. If excess foaming occurs, a silicone anti-foaming agent may be added (e.g. Halt^®).
5. Complete filling the tank to the desired level with water. If agitation is stopped for more than 5 minutes, re-suspend spray solution by full agitation prior to commencing spraying again.
6. Between loads of tank mix, check in-line and nozzle screens and rinse and clean if necessary.
7. Upon completion of spraying, thoroughly flush tank, boom, hoses and in-line and nozzle screens with clean water to avoid possible injury to other crops.

Follow crops⁴

1 year after application

Chickpeas, Clearfield canola, field corn, field peas, lentils (incl. Clearfield lentils), soybeans, spring barley, spring wheat, tame oats⁵

2 years after application

Canola⁶, canary seed, durum wheat, flax, sunflowers

_{4 Refer to label for additional follow crop restrictions. Contact your BASF Sales Representative for details on any crops not listed here.}

_{5 If drought conditions are experienced between June 1 and September 1 in the year of application, delay planting of tame oats by an additional year.}

_{6 If drought conditions are experienced between June 1 and September 1 in the year of application or between June 1 and September 1 in the year following application, delay planting of canola (non-Clearfield) by an additional year.}